Internal Control Module Memory Checksum Error. This diagnostic trouble code has detected an abnormal operating condition or electrical signal failure. The Powertrain Diagnostic Subsystem controls essential electronic fuel, air, and ignition parameters to maintain stable combustion and low exhaust emissions. When this circuit fails, the vehicle computer illuminates the Check Engine / Warning Light and may log an active diagnostic fault code.
Related Components (Photo & Inspection)
2 Components (Tap to Zoom)
EOT Sensor (Engine Oil Temperature)
Click to inspect photo & test specs
12V Motorcycle Battery
Click to inspect photo & test specs
- • Check Engine Light (MIL Lamp): Illuminates or flashes on the speedometer console.
- • Engine Hesitation & Jerking: Poor throttle response during sudden acceleration.
- • Drop in Fuel Economy: Open-loop fuel spraying increases petrol consumption and causes black smoke.
- • Hard Cold Starting: Engine dies during idle or requires multiple starter button attempts.
- • Wiring Harness Damage: Chafed wires touching motorcycle frame metal or rodent cuts.
- • Loose / Corroded Coupler: Green oxidation or loose push-fit pins inside connector plug.
- • Defective Component: Burnt internal sensing thermistor or solenoid actuator coil.
- • Low Battery Voltage: Weak motorcycle battery under 12.0V causing ECU reference error.
Step-by-Step Diagnostic & Repair Procedure
Bench-tested repair procedure for code P0601