Motorcycle OBD-II DTC Fault Codes Directory
Step-by-step diagnostic checks, multimeter testing values, wiring inspections & OBD-II erase guides for BS6 two-wheelers.
OkBike Mechanic App
Live sensor graphs, 1,000+ color wiring diagrams, ECU pinouts & OBD-II scanner.
Two-Wheeler Diagnostic Fault Categories
Select a category to view OBD-II trouble codes for two-wheeler systems.
P0100 - P0199: Fuel & Air
MAP, TPS, IAT, ECT, and Oxygen (O2) sensors.
P0200 - P0299: Fuel Injection
Fuel pump relay, injector circuit open/short.
P0300 - P0399: Ignition & Misfire
Spark plugs, ignition coils, CKP crank sensor.
P0500 - P0599: Speed & Idle
Vehicle speed sensor (VSS), ISC idle actuator.
P0600 - P0699: Computer & ECU
ECM processor, MIL lamp circuit, 5V reference.
U0000 - U0999: CAN Network
CAN-Bus communication with ABS or speed meter.
Motorcycle OBD-II Diagnostics FAQ
Frequently asked diagnostic questions by Indian bike technicians and garage owners.
What is an OBD-II DTC fault code on a BS6 motorcycle?
A Diagnostic Trouble Code (DTC) is a standardized alphanumeric code stored by the motorcycle's Engine Control Unit (ECU). When any sensor (such as MAP, TPS, O2, or EOT) reads voltage or resistance outside calibrated limits, the ECU illuminates the Check Engine Light (MIL) and saves the fault code into internal memory.
How do I scan and clear codes on Hero, Honda, Bajaj, and TVS bikes?
Connect a compatible Bluetooth OBD-II scanner to the motorcycle's 4-pin (Euro 5/BS6) or 6-pin diagnostic DLC connector located under the seat or side panel. Open the OkBike Mechanic App to read live ECU sensor streams, interpret error codes, and execute "Clear DTC Fault Memory".
Why does the Check Engine Light stay ON after replacing the damaged sensor?
The ECU stores historical error data in non-volatile memory. Even after installing a new genuine component, the light will remain illuminated until either an OBD-II scan tool clears the code or the motorcycle completes 3 to 4 warm-up drive cycles without detecting the fault again.
Can I safely ride a motorcycle when the Check Engine Light is flashing?
A steady MIL indicates a minor emissions or sensor fault (limp mode may be active), but a flashing MIL signals a severe engine misfire or extreme lean condition. Continuing to ride with a flashing light can melt catalytic converter internals or cause severe engine piston seizure. Turn off the motorcycle immediately and tow to a workshop.
What tools are needed to test sensors before replacing them?
A certified technician only needs a digital multimeter (testing 5V reference, chassis ground continuity, and sensor resistance in ohms), backprobe sewing pins for harness couplers, and an OBD-II diagnostic tool to verify live sensor graphs.