HO2S Sensor Correlation Bank 1 Sensor 1/Bank 1 Sensor 2. This diagnostic trouble code indicates a timing or position mismatch between two linked sensors (such as crankshaft vs camshaft, or dual wheel speed sensors). The Oxygen Sensor (O2 / Lambda Sensor) measures residual oxygen content in exhaust gases so the engine computer can maintain the ideal 14.7:1 stoichiometric air-fuel mixture. When this circuit fails, the vehicle computer illuminates the Check Engine / Warning Light and may log an active diagnostic fault code.
Related Components (Photo & Inspection)
5 Components (Tap to Zoom)
EOT Sensor (Engine Oil Temperature)
Click to inspect photo & test specs
Oxygen Sensor (O2 / Lambda Sensor)
Click to inspect photo & test specs
Crankshaft Position (CKP / Pickup Coil)
Click to inspect photo & test specs
Vehicle Speed Sensor (VSS)
Click to inspect photo & test specs
12V Motorcycle Battery
Click to inspect photo & test specs
- • Check Engine Light (MIL Lamp): Illuminates or flashes on the speedometer console.
- • Engine Hesitation & Jerking: Poor throttle response during sudden acceleration.
- • Drop in Fuel Economy: Open-loop fuel spraying increases petrol consumption and causes black smoke.
- • Hard Cold Starting: Engine dies during idle or requires multiple starter button attempts.
- • Wiring Harness Damage: Chafed wires touching motorcycle frame metal or rodent cuts.
- • Loose / Corroded Coupler: Green oxidation or loose push-fit pins inside connector plug.
- • Defective Component: Burnt internal sensing thermistor or solenoid actuator coil.
- • Low Battery Voltage: Weak motorcycle battery under 12.0V causing ECU reference error.
Step-by-Step Diagnostic & Repair Procedure
Bench-tested repair procedure for code P00D5